Part Two: 8 Mode Rapid Fire Mod Install (Matrix)- EvanMods.com

EvanMods.com - The go-torapid fire controller site for pre-modded controllers, kits, and other xbox 360 modding items. Buy the affordable pre-programmed mod chips and install them in your own controllers. Then just re-sell them for profits! My channels youtube.com youtube.com Please subscribe to both channels to stay tuned for any new videos I upload!! This shows you how to install the rapid fire in a Matrix (old) style circuit board. Go to EvanMods.com for the mod components like the chip, resistors, diode, wire, and even the screwdriver! You will still have to watch the video to know where to solder to but I have the wire lengths and solder points below for general purposes. The wire lengths and what pin to solder to are as followed 6in, Solder to the small hole on the left side of the circuit board to the 1st pin on the left side of the microchip 2in, Solder to the led and solder the diode to the wire and then to the 2nd pin on the left side 8in, Top solder point of the small black component on the top left of the circuit board to the 3rd pin on the left side .5in, 4th pin to 1st pin on the left side 3in, Solder to the point left of the headset jack to the 1st pin on the right side of the microchip 1.25in, Solder to the right trigger's resistor to the 2nd pin on the right side 6in, Solder to the resistor of the left trigger and then to the 3rd pin on the right side of the chip I hope this helps and contact me with any questions.
Author: Evanator22742
Duration: 10:24



Photos for video
Part Two: 8 Mode Rapid Fire Mod Install (Matrix)- EvanMods.com